| Home > Retrofit Add-on Toilet Seat Bidet Easy Install > |
| Simple Installation Bidet Easy Install Instructions More detailed instructions with pictures comes with the bidet. 1. Remove the Existing Toilet Seat and Lid Unfasten the nuts and remove toilet seat. 2. Mount the Bidet on the Toilet The mounting bolts adjust into three different mounting widths to accomodate different toilets. Insert the mounting bolts into the toilet mounting holes and fit the core packings, plastic washers and nuts on from below. 3. Connect the Branching or Splitter Valve Turn off water at the supply valve. Flush the toilet and hold down the lever so that the tank drains as completly as possible. You might want to place a small pan under the supply valve to catch water that will dribble out of the hoses as you disconnect them. Disconnect the hose from the supply or shut-off valve and the tank. Attach the branching valve (supplied) to the supply valve. If your supply valve is 3/8" you will need to use the adapter (supplied). 4. Hook up the Hoses Use the two hoses (supplied) to connect the branching valve to the tank and the branching valve to the bidet. Turn on supply valve and check for leaks - tighten as necessary. 5. Plug in Bidet The electrical supply must be 120 volt, 60 Hz, and at least 10 Amp three prong grounded outlet. A Ground Fault Interrupter (GFI) should be on the circuit supplying power to the bidet. |
Copyright 2002-2007 by naturestapestry.com. All Rights Reserved. |